Installing a Brick Paver Walkway or Decorative Brick Blocks

The use of Bricks or Pavers to create a sidewalk or patio matches a home in a way that is unrivaled. In addition, installing a Brick or Paver sidewalk does not necessarily require a pro.

The key to installing a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be set up. In addition, string lines ought to be strung on each side of the sidewalk.
When the location has actually been dug down, 3/4" gravel stone should be laid in and tamped down firmly. The height in between the tamped down sand and the stringline should equal the thickness of the brick or paver.

Now that you have a steady base, put a 1" pipeline or journal board the length of the walkway on either side of the pathway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up a work on both sides of the ready location. These strips will act as your walkway border and help to preserve the stability and shape of the pathway. You can get these plastic strip borders at the majority of house enhancement shops. The strips should be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.

You can then begin to lay the bricks/pavers once this is done. There are many patterns you can lay. I particularly like the Herring Bone pattern. The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again assist preserve the integrity of the walkway.

When constructing the sidewalk, undoubtedly bricks/pavers will need to be cut or divided. Unless you desire to buy or rent a pricey wetsaw, I would recommend buying a simple brick/paver splitter. It is basically a sculpt with a wide end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you wish to break the brick. Using a hammer strike get more info the butt end of the sculpt securely. You may require to do this a couple of times. You might likewise want to turn the brick/paver over and strike the other side of the brick using the hammer and chisle. Within a couple of strikes the brick/paver ought to break cleanly. If your sidewalk has curves you will need to buy/rent a wetsaw.

After installing the bricks, develop the outside edges with extra sand, and then shovel in the topsoil and load down strongly.
Spread stone dust over the new pathway and sweep into the fractures. This will complete the interlocking of the bricks and help to get rid of any weed development.


In addition, setting up a Brick or Paver pathway does not always need a pro. The key to installing a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be set up. Now that you have a read more steady base, place a 1" pipe or ledger board the length of the pathway on either side of the sidewalk. These strips will act as your sidewalk border and assistance to keep the integrity and shape of the walkway. Inevitably bricks/pavers will require to be cut or split when building the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *